D-Line Cable Trunking

Accessory Name Description Size Weight Circular Adaptor Connect Mini D-Line to flat edge surface boxes with 20mm diameter 3 circular knock-outs 30x15mm 5g Patress Adaptor Connect Mini D-Line(interfaces with 30x15mm only) to round Surface Boxes 30x15mm 3g Cable Inlet/Outlet Takes cables in or out of a 30x15mm installation. Use between lengths on straight runs 30x15mm 2g End Cap Internal Bend External Bend Flat Bend Equal Tee Cable Inlet/Outlet Connector After Care • Measure length(s). Pencil mark where cut is required. • Use a mitre block and junior hacksaw to cut at the outer edge of the pencil mark. • Remove the protective film cover. • Peel & stick.. Make sure the surface is clean & dry. Alternatively lengths can be drilled and screw fixed. • For easier installation we recommend that horizontal runs are fixed with the click lock at the top and the hinge at the base. • Take care when positioning lengths, as a strong bond will be created with the surface. D-Line can accept gloss or emulsion paints... For best results use fine sandpaper to key the surface prior to painting. It may be necessary to shape some accessories to allow for imperfections on walls. Installing cables & accessories Lay cables into lengths, place the required accessory over the cables, then close the lid ensuring it snaps shut. The lengths hold the accessories in position. example... lengths need to touch Important: If using D-Line for 240v mains cables it is recommended you leave 45%+ of internal capacity for air circulation. Installation Tips Plan your cable path. Check that you have all parts required. Next consider the space that will be required for any accessories needed - Smooth-Fit ccessories give a smooth flush-alignment for perfect finish, but require precise measurements and straight cuts. Use the accessory part as a template; pencil mark the surface at the shoulder points of the accessory. These pencil marks indicate the point that the D-Line length needs to measure up to.